Programming User Code Directions for Birmingham Office 1F Break Room Lockers


You will need a paperclip or something thin and pointy.


Programming the User Code

  • Use these steps to change your current user code. 
  • The factory default code is 0000. 
  • User codes must be 4 to 8 digits in length. 
  • Note that the user code can not be changed if the Receiver Latch has been set to Single Use Mode.
  • There is a 60 second programming time limit to each step. If you time out or make an error, programming will end and you will need to restart from step 1.


  1. We suggest reading through the instructions prior to beginning programming 
  2. Press and hold the Receiver Latch learn button (On the inside latch mechanism) until the yellow LED light begins a one blink pattern, then release
  3. Using the Transmitter Pad (The outer keypad) enter the current user code (Default is 0000) and press the Unlock button
  4. Wait for green light on Transmitter Pad to turn off then enter the new user code and press the Lock button
  5. Wait for green light on Transmitter Pad to turn off then re-enter the new user code and press the Lock button to secure code
  6. If successful, the green LED light on the Receiver Latch will stay illuminated for 3 seconds
  7. Once the green LED light has turned off, the Receiver Latch will automatically exit the learn mode
  8. Test lock function with new code
  9. We recommend writing down your new code in the back of these instructions and storing in a safe area



https://compx.com/resources/is-600-stealthlock-instructions.pdf